Newbie Question about Comet Flash Bulb

[Chill]

I noticed that the flash bulbs under the corkscrew ramp weren't working, so I replaced them. The problem that caused the problem, it would appear, is that those flashers stay on permanently. Even I know enough to recognize that's a bad thing, so I took one out and shut them both off.

Is there a relatively easy fix, or do I need to bring in a technician? I am willing to learn, and this might be a good opportunity.

Thanks!

[spalmer]

Check near by for a small board with a resistor. That machine uses a keep warm circuit on the flasher bulbs. If that resistor is shorted, you will have the problem you are describing. If that is not the problem, I will give you the alternative. Not as easy but I can talk you through it.

[Chill]

I'll check it out. Thanks for the advice!