View Single Post
  #3  
Old 11-11-2015, 11:52 AM
pinballdaveh's Avatar
pinballdaveh pinballdaveh is offline
Pinball Technician
 

Join Date: Aug 2012
Location: poconos
Posts: 895
Credits: 0.00
Thanks: 214
Thanked 321 Times in 272 Posts
Rep Power: 17
pinballdaveh is a jewel in the roughpinballdaveh is a jewel in the roughpinballdaveh is a jewel in the roughpinballdaveh is a jewel in the rough
Default

what a mistake on williams part to design a wire termination jack connector system that would allow this to happen. instead of using 2 connectors the same size why not use 4 connectors all with different amount of pins, different sizes, and keyed different. that should make connector assembly mistakes to a minimum. its hard to imagine what voltages going to parts of the boards that dont belong. sorry to say this but the cpu, power supply, and driver boards should be sent to a board tech or be replaced. sounds and speech boards might have been spared because they arent involved directly with the playfield.
Reply With Quote